Bonded ADSL - Load Balanced
Technical Details
Nildram provide either a Load Balanced Solution (below) or a Bonded Solution
Load Balanced Solution:
Requirements
- Each ATM interface has own dialer interface
- Dialer interfaces use same login
- Dialer interfaces allocated IPs from dynamic pool on LNS
- LNS routes a subnet via all of the allocated dynamic IPs
- CPE has default route via remote IP of each dialer interface, which is LNS IP and same for each
This service will not allow you to use:
- Where IPSEC VPN from CPE is required
- With non-Cisco CPE such as LINUX bonded solution
Login name format will be 'gotadsl.co.uk/login-ml2' where 'login' is the username that is specified in your welcome letter.
- VPI: 0
- VCI: 38
- PPP Type/Encapsulation: PPPoA (PPP over ATM) NOT PPPoE
- Framing: VC-MUX
- Modulation/Mode: G.DMT
Ports blocked: None.
- DNS Primary: 212.139.132.5 or 212.139.132.6
- DNS Secondary: 212.139.132.21 or 212.139.132.22
- MTU: 1500
Speed test: http://www.adslguide.org/tools/speedtest.asp or
http://www.myspeed.co.uk (this site is based on the Nildram network)
If this section doesn't meet your needs or you require further assistant then please contact support.